Optimizely Campaign SOAP API
SOAP API Overview
The SOAP API is compatible with the most common platforms (e. g.
BlacklistWebservice
Note that there is a difference between a blocklist entry and a blocked email address. Since blocklisting can be done using wildcards (see next section), a blocklist entry may block several email addresses.
ClosedLoopWebservice
To use this web service, you must have the closed loop interface and should be familiar with the closed loop process.
CouponBlockWebservice
The WSDLs for the coupon code system can be found under these links https //api. campaign.
CouponCodeWebservice
The WSDLs for the coupon code system can be found under these links https //api. campaign.
FolderWebservice
Folders are used in several functions in Optimizely Campaign, for example, to store mailings or target groups in them. The folderType parameter is used to indicate whether a folder contains mailings or target groups.
MailIdWebservice
A mail ID identifies a single mail that has been sent to a single recipient. It is the aggregation of these three IDs mailing ID , recipient list ID and recipient ID .
MailingWebservice
The following mailing types are supported regular This is a regular mailing. event This mailing type is used for trigger emails.
RecipientFilterWebservice
Temporary target groups are only valid during the current session. These target groups can be used in ad hoc queries.
RecipientWebservice
Attribute values have to be provided in a serialized form. See \[Type conversion and formatting rules]doc\ soap-1-1-compatibility).
ResponseWebservice
Use one of the following values whenever a category is required hardbounce softbounce autoresponder unknown In addition to these response types, you can use any recipient-defined response type too.
SessionWebservice
Some methods (mostly reporting functions) require parameters for localization. The localization version for the current session can be set active by using the setLocale https //docs.
Soap11Webservice
Methods defined within this web service are available through every web service. This web service cannot be accessed directly.
SplitMailingWebservice
To create mailings to be used as splits, use the MailIdWebservice https //docs. developers.
UnsubscribeWebservice
Each client uses one unsubscribe list. If there is an unsubscribe for any recipient list the recipient is added to this list and will not receive any further mailings send by this client.